Miele PWM 912 EL, Installations Plan

Page: 42 / 130

en - Technical data
42
Plumbing
Cold water connection
Required flow pressure 100 - 1000 kPa (1 - 10 bar)
Maximum flow rate 31,5 l/min
Threaded union required (male thread, to be provided by customer in accordance with
DIN 44991, flat sealing) 3 x 3/4"
Length of water inlet hose supplied 3 x 1550 mm
Hot water connection
Maximum permissible hot water temperature 70 °C
Required flow pressure 100 - 1000 kPa (1 - 10 bar)
Maximum flow rate 16 l/min
Threaded union required (male thread, in accordance with DIN 44991, flat sealing) 1 x 3/4"
Length of water inlet hose supplied 1550 mm
Hot water connection (for variants without heating or with reduced heater rating)
Maximum permissible hot water temperature 90 °C
Required flow pressure 100 - 1000 kPa (1 - 10 bar)
Maximum flow rate 16 l/min
Threaded union required (male thread, in accordance with DIN 44991, flat sealing) 1 x 1"
Length of water inlet hose supplied 1550 mm
Hard water connection (optional)
Required flow pressure 100 - 1000 kPa (1 - 10 bar)
Maximum flow rate 32 l/min
Threaded union required (male thread, in accordance with DIN 44991, flat sealing) 2 x 3/4"
Length of water inlet hose supplied 2 x 1550 mm
Drainage
Maximum drain water temperature 95 °C
Waste water connection (on machine) Plastic pipe HT DN 70
Drain (on site) Connection DN 70
Maximum drainage rate 200 l/min
Connection for equipotential bonding
Male thread M10
Toothed washers M10