Selecting further settings
55
Switching off Demo mode
Demo mode
allows the refrigeration
appliance to be presented in the show-
room without the cooling system being
switched on. This setting is not needed
for domestic use.
If Demo mode has been switched on
as a default setting,
will show on the
start display.
Tap
.
Tap
.
Swipe left or right until
is shown in
the middle.
Tap
.
After Demo mode
has been switched
off, the refrigeration appliance shuts
down and must be switched on again.
Resetting the settings to their default
settings
All settings made on the refrigeration
appliance will be reset to default set-
tings (for settings, see “Guide to the ap-
pliance”).
Tap
.
Swipe left or right until
is shown in
the middle.
Tap
.
will appear on the display.
Tap
OK
.
The refrigeration appliance shuts down
and must be switched on again.
Information
Appliance data (model number and
serial number) is shown on the display.
Tip:
This data is important when report-
ing an appliance fault to the Miele Cus-
tomer Service Department (see “Ser-
vice”).
Charcoal filter change indicator
After inserting the charcoal filter (op-
tional accessory), you must activate the
charcoal filter change indicator
in
Settings mode
.
The charcoal filter change indicator
on the start display will remind you to
replace the charcoal filter approx.
every 6 months (see “Cleaning and
care – Replacing the charcoal filters”).
Cleaning mode
Cleaning mode
makes it easier to
clean the fridge zone (see “Cleaning
and care”). The interior lighting re-
mains switched on, even though the
fridge zone is switched off. The buzzer
will stop and the symbols on the dis-
play will also go out.
If Cleaning mode
is switched on,
this will be indicated on the start dis-
play.
After cleaning, Cleaning mode
must
be switched off. If the appliance door is
closed for more than 10 minutes,
Cleaning mode
switches itself off
automatically.
Summary of Contents for KFN 7795 D
Page 30: ...Guide to the appliance 30 ...
