Installation advice
59
Side-by-side units
The appliance has two side-wall heaters
encased in foam and can be installed
side-by-side with other appliances.
Each appliance must be installed in its
own housing unit.
Please contact Miele for information
on which combinations are suitable for
your appliance.
Risk of injury and damage!
This appliance must be built in,
otherwise it could tip over. To avoid a
hazard, it must be fixed in
accordance with the instructions.
Keep the appliance door(s) shut until
the appliance has been built in and
secured in its housing in accordance
with these operating and installation
instructions.
Fire risk and danger of damage!
This refrigeration appliance must not
be installed underneath a cooktop.
Location
This appliance should be installed in a
dry, well-ventilated room.
When deciding where to install your
refrigerator please bear in mind that it
will use more energy if installed near a
heater, cooktop or other appliance that
gives off heat. Direct sunlight should
also be avoided.
The higher the room temperature, the
longer the compressor will run and the
higher the energy consumption will be.
When installing the appliance, please
note:
– The mains socket must not be
located directly behind the appliance
and must be easily accessible.
– The plug and cable must not touch
the rear of the appliance as they
could be damaged by vibrations from
the appliance.
– Nor should other appliances be
plugged into a socket located directly
behind this appliance.
