At the end of the activation phase
the
steam injection system will need to be
cleaned to remove all traces of
descaling solution.
Cleaning is carried out by flushing
approx. 1 litre of fresh tap water
through the system. The water is
collected in the universal tray. This
process is repeated three times.
A message will appear in the display
with advice about the rinsing process.
N
Take the universal tray out of the
oven and empty it. Place the tray
back in the oven again on the top
shelf level.
O
Detach the plastic tube from the
container.
P
Rinse the container and fill with
approx. 1 litre of fresh tap water.
Q
Place the container back in the oven,
insert the plastic tube, secure it to
the container and close the door.
R
Touch the OK sensor.
The intake process for the
first rinse
starts.
Water will be flushed through the steam
injection system and will then collect in
the universal tray.
A message will appear in the display
with advice about the
second rinsing
process
.
S
Take the universal tray out of the
oven and empty it. Place the tray
back in the oven again on the top
shelf level.
T
Remove the plastic tube from the
container. Rinse the container and fill
it with approx. 1 litre fresh tap water.
U
Place the container back in the oven,
insert the plastic tube, secure it to
the container and close the door.
V
Touch the OK sensor.
W
Do the same for the
third rinsing
process
.
Leave the universal tray (with the
water which has collected in it during
the third rinsing process) on the top
oven shelf whilst the evaporation
process takes place.
X
Remove the container and tube from
the oven.
Cleaning and care
114
