Electrical connection UK, IRL, ZA
All electrical work should be under-
taken by a suitably qualified and
competent person in strict accord-
ance with national and local safety
regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer can-
not be held responsible for unauth-
orised work.
Ensure power is not supplied to the
appliance while installation or repair
work is being carried out.
The
voltage, rated load and fusing
are given on the data plate, visible
below the oven interior, with the oven
door open. Ensure that these match the
household mains supply. Please quote
these data, and the model and serial
number when contacting the Miele Ser-
vice dept.
Connection of this appliance should be
made either via a fused connection unit
(rated load under 3000 W), or via a suit-
able isolator (rated load over 3000 W),
which complies with national and local
safety regulations, and the on/off switch
should be easily accessible after the
appliance has been built in.
If the socket is not accessible after in-
stallation (depending on country) an ad-
ditional means of disconnection must
be provided for all poles.
For extra safety it is advisable to install
a residual current device with a trip cur-
rent of 30 mA (in accordance with DIN
VDE 0664, VDE 0100 Section 739).
When switched off there must be an all-
pole contact gap of 3 mm in the isola-
tor switch (including switch, fuses and
relays acc. to EN 60 335).
Connection diagram
Electrical connection UK, IRL, ZA
66