Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^
Decrease the rinse aid dosage.
^
Switch the dishwasher off using the
K
button.
^
Press the Start/Stop button in and
whilst holding it in
switch the
dishwasher on using the
K
button.
Keep the Start/Stop button pressed in
until the Start/Stop indicator comes
on.
If this does not happen, start the
procedure from the beginning again.
^
Press the Delay start button three
times.
The lowest programme indicator will
flash briefly three times at intervals.
The Wash/Rinse indicator will flash
briefly three times at intervals.
This means that approx. 3 ml of rinse
aid will be used per programme
(factory default setting).
The number of times the Wash/Rinse
programme sequence indicator flashes
tells you the rinse aid dosage which
has been set (see chart).
Rinse aid
in ml
"Wash/Rinse"
flash frequency
0
-
1
Once
2
Twice
3
Three times
4
Four times
5
Five times
6
Six times
^
Use the Start/Stop button to select
the number of flashes which equates
to the rinse aid dosage you want.
Each press of the button moves you
up a level.
The programmed rinse aid dosage is
now stored in memory.
^
Switch the dishwasher off using the
K
button.
Before using for the first time
21
Summary of Contents for G4302 SCU
Page 61: ...61 ...
Page 62: ...62 ...
Page 63: ...63 ...
Page 64: ...Alteration rights reserved G4300 G4302 G4305 G4307 0511 M Nr 09 048 470 00 ...