Installationsplan G 7856
Stand: 19.01.2004
Seite 5
Plug and socket connection recommended to facilitate
electrical safety tests. Socket must be accessible after
installation. On hard-wired machines, a multi-pole circuit
breaker with a minimum contact gap of 3 mm must be
provided on site. The use of an earth leakage circuit breaker
(ELCB) is strongly recommended.
If necessary, equipotential bonding with good galvanic contact
must be provided in accordance with all appropriate national
and local regulations.
Cold water
Max. water hardness
°dH
60
Min. flow pressure
kPa
200
Max.
pressure
kPa 1000
Throughput
l/min 7.5
On-site connection thread according to DIN 44 991
Inch
3/4" external thread
(USA: 11.5 NH)
Length of connection hose (supplied)
mm
1700
DVGW
approved
Water connection Australia:
To prevent back-syphonage, the water connection must be
via an approved Dual-Check-Valve supplied with the
machine.
Hot water
Max. temperature
°C
70
Max. water hardness
°dH
60
Min. flow pressure
kPa
200
Max.
pressure
KPa 1000
Throughput
l/min 7.5
On-site connection thread according to DIN 44 991
Inch
3/4" external thread
(USA: 11.5 NH)
Length of connection hose (supplied)
mm
1700
DVGW
approved
Water connection Australia:
To prevent back-syphonage, the water connection must be
via an approved Dual-Check-Valve supplied with the
machine.
Drain hose (Int. dia. × wall thickness × l)
mm
22 x 6 x 1500
Max. head height (measured from floor)
m
1.0
Max. transient throughput per drain hose
l/min
16
Waste water
Hose sleeve for drain hose to be provided on site
(ext. dia. x l)
mm
22 x 30
External
dispensing
(optional)
Dispenser connection (DOS G 60) for liquid detergent at rear
of machine
Machine
data
Height
mm 850
Width
mm
598
Depth
mm
600
Installation should only be carried out by authorised fitters in accordance with valid regulations!
Observe installation instructions when installing machine! Adjacent cabinetry should be made from commercial-grade
materials to prevent damage from steam and condensate. All rights reserved! Measurements in mm
