Before using for the first time
27
Setting the water hardness level
The display will change to the screen
for setting the water hardness.
- You should programme the
dishwasher to the correct water
hardness for your area.
- Your local water authority will be able
to advise you of the water hardness
level in your area.
- Where the water hardness fluctuates
e.g. between 1.8 and 2.7 mmol/l (10 -
15 °dH - German scale) always
programme the dishwasher to the
higher value (2.7 mmol/l or 15 °dH in
this example).
In the event of a fault, it will help the
service technician if you know the
hardness of your local water supply.
Therefore, please enter the water
hardness:
____________°dH or mmol/l
The dishwasher is programmed at the
factory for a water hardness level of
2.5 mmol/l (14 °dH – German scale).
Set the water hardness level in your
area and confirm using
OK
.
See the “Settings” chapter, “Water
hardness” section for more
information.
Activating AutoDos
The display changes to the settings
screen for AutoDos (see “Detergent –
Automatic dispensing/AutoDos”).
Even if you do not wish to use
AutoDos, you must remove the
transport locking device from the
PowerDisk compartment before
running the first programme
sequence (see “Detergent –
Activating AutoDos”).
You can activate AutoDos.
If you do not wish to use AutoDos
(automatic dispensing), you can
manually dispense the detergent via the
detergent compartment (see “Detergent
– Manual detergent dispensing”).
Select the setting you want and
confirm with
OK
.
This setting applies to all programmes
and can be changed at any time using
the
AutoDos
button.
