Checking the water level
Checking the water level
If the water pressure (flow rate at the
take-off point) is too low, i.e. less than
100 kPa, too little water will flow into the
wash cabinet.
To ensure an accurate assessment
open the stopcock fully and run the
COLD PRE-WASH programme once
(without crockery) to bring water into
the system.
Run the COLD PRE-WASH pro-
gramme again. After approx. 3
minutes open the door and remove
the bottom basket from the machine.
The water level is correct when dimen-
sion
“X”
is at least 4 mm.
If it measures less, then the water in-
take time must be increased.
Checking the water level
39
