Setting the temperature
^
Use both sensors underneath the
display to set the temperature.
By touching
– the down arrow, the temperature
decreases
– the up arrow, the temperature
increases
While the temperature is being set, the
temperature value will flash.
When you tap the sensors, you will see
the following changes in the display:
– When first tapped: The
last
temperature selected
flashes.
– Each subsequent touch of a sensor:
The temperature is adjusted in 1 °C
steps.
– Leaving a finger on the sensor: The
temperature changes continuously.
Approximately 5 seconds after you
release the sensor, the
actual
temperature in the appliance will be
displayed.
When you have adjusted the
temperature, wait for
approx. 6 hours
if the appliance is not very full
and for
approx. 24 hours if the appliance is
full
before checking the temperature
display, as it will take this long for the
appliance to reach the temperature.
If, after this time, the temperature is still
too high or too low, you will need to
adjust it again.
Temperature range
The temperature can be adjusted
between -15 °C and -28 °C.
The correct temperature
22
Summary of Contents for FN 35402 i
Page 81: ...81 ...
Page 82: ...82 ...
Page 84: ...M Nr 09 943 050 00 en AU NZ FN 35402 i FN 37402 i FNS 35402 i FNS 37402 i ...
