Problem solving guide
71
Problem
Cause and remedy
Empty the drip tray and the
waste container
appears
in the display, even
though the drip tray has
been emptied.
The drip tray is not positioned correctly in the ma-
chine.
Push the drip tray in as far as it will go.
Make sure that the lower panel is sitting on the
drip tray correctly.
Insert the drip tray and the
waste container
appears
in the display even
though both are fitted.
The drip tray is not in the correct position and is
therefore not detected.
Empty the drip tray and the waster container. Re-
assemble all parts and push the drip tray back in
the coffee machine until it clicks into position.
The machine is open.
Close the machine.
If necessary, empty the drip tray and the waste
container. Reassemble all parts and push the drip
tray back in the coffee machine until it clicks into
position.
The drip tray or waste
container is full or over-
flowing, although they
have been emptied fol-
lowing each reminder.
This is not a fault.
The drip tray and waste container were probably re-
moved or the machine was opened without the drip
tray and waste container being emptied. When the
drip tray is removed or the machine opened, the in-
ternal counter for emptying the drip tray and waste
container is automatically reset.
Remove the drip tray and waste container from the
machine and empty them.
Fill the bean container
ap-
pears in the display
even though the bean
container has just been
filled.
This is not a fault.
Confirm the message with
OK
.
The coffee machine
does not rinse itself
when turned on.
This is not a fault.
If the coffee machine still has an operating temperat-
ure higher than 60 °C, rinsing will not take place.
