Miele 41CRP331CE, Operating Instructions Manual

Page: 45 / 128

en
45
 Replace it with a new AirClean ex-
haust filter.
If you wish to fit an AirClean Plus 50,
Active AirClean 50 or HEPA
AirClean 50 exhaust filter, see “Re-
placing one type of exhaust filter with
another”.
 Close the filter grille.
 Close the dust compartment lid.
Replacing the AirClean Plus 50,
Active AirClean 50 and
HEPA AirClean 50 exhaust filters
(dia. 36 + 37)
Do not use more than one exhaust fil-
ter at a time.

Open the dust compartment lid.

Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making
sure it goes in properly, then press it
down into position.
 If you are using exhaust filter c or d ,
press the timestrip
®
filter change in-
dicator (dia. 12).
After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (dia. 13).
If you wish to fit an AirClean exhaust
filter, see “Replacing one type of ex-
haust filter with another”.
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 09)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b AirClean Plus 50 (light blue)
c Active AirClean 50 (black)
d HEPA AirClean 50 (white)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter, please note
1. If you wish to replace exhaust filter a
with filter b , c or d , it is essential that
you remove the filter grille before you
fit the new exhaust filter.
If you are using exhaust filter c or d ,
you must also activate the timestrip ®
filter change indicator (dia. 12).
2. If you wish to replace exhaust filter b ,
c or d with filter a it is essential that
filter a is fitted in the filter grille* (dia.
35).
* Filter grille – see “Optional ac-
cessories”
Replacing the thread lifters
(dia. 38 + 39)
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.