Weld
Pin
1. If “B” Stop is used, seat weld pin firmly
against stop.
2. Loosen these adjustment screws.
3. Slide the Leg / Foot assembly until
weld pin flange extends 1/8"- 3/16"
beyond foot.
4. Retighten adjustment screw.
Adjustable
Leg /Foot
1/8"- 3/16" Protrusion
“B”
Stop
(optional)
“B”
Collet
(inside
Protector)
Collet
Protector
Collet
Protector
Insert
MIDWEST FASTENERS
800-852-8352
MIDWEST FASTENERS
800-852-8352
Remove the controller, cables and weld gun from the shipping packaging.
Connect the Cable connectors to the controller as marked: “CD” or “CUPHEAD”
depending on the fastener type to be welded.
NOTE:
All cables should be
laid out straight or in large loops.
CD-2T WELD GUN
SETUP
CUPHEAD PINS
CD-2T WELD GUN
SETUP
INSULATION PINS
WITH
COLLET PROTECTOR
Cuphead
Pin
1. Place POSI-Weld magnetic chuck in gun shaft and
retighten set screw.
2. Place Cup Head Pin on magnetic chuck.
NOTE:
A) When welding, maintain correct pressure
on gun (approximately 1/8" of gun spring.)
B) When welding through Foil Faced Insulation (FSK),
always use Cuphead Pins
with
paper washer installed.
POSI-Weld
Magnetic
Chuck
PARTS
MIDWEST FASTENERS INC.
SETUP
CDWG-201-35
