Locate the 4 Bolts and 4 Washers, and secure the panels together.
13
Tighten all bolts in all locations.
14
Install the 4 Plastic Caps (K) in the openings on the top of the cage.
15
Fully open the doors by pinching the knobs on the doors together.
16
Insert the Middle Pan (D) in the upper unit. Be sure the cut-out is positioned to match up with the opening
in the Middle Panel Grid.
17
Note: The Shelves, in conjunction with the Side Panels, can be positioned at 3 different levels on either side of the
cage. Although all three levels provide a ferret appropriate angle for the ramp, for these instructions, the middle
position will be demonstrated.
Locate one Shelf (I) and with the doors
open in the top unit, tilt the Shelf down
and insert the end of the hook in the middle
holes on the right side of the top unit. Lift the
Shelf up and let hook fall into place.
18
Before inserting the Shelf in the bottom unit, install the Ramp (J) that will
allow your ferret go from one level to the next. Attach the hooks on the
end of the ramp to the back wire in the opening of the Middle Panel Grid.
19
This ramp has the ability to be secured in the “up”
position to section off the top level from the
bottom level. Before inserting the Shelf in the
bottom unit, swing this ramp up and hook it with
the attached “S” hook.
(For illustration purposes,
this is shown without the pan installed.)
20
Install Shelf in bottom unit as in Step 19.
21
Attach the remaining ladders on the shelves.
Slightly tilt the shelf up and slip the hooks of the
ladder onto the outermost wire on the shelf. To keep
the shelf from moving from side to side, be sure the
ladder hooks are placed in the openings as shown.
22
3
FN-143 (511)
