10
11
DOCKER SERIES INSTALLATION GUIDANCE
midstreamlighting.com
+44 (0) 207 584 8310
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
7. Electrical connection
The power supply cable and the control cable are not supplied
V+
V-
SCALE 3:10
SEE DETAIL
A
GROUND
Dim
+
Dim
-
12v
NEUTRAL
Dim
+
Dim
-
12v
LIVE
Dim
+
Dim
-
12v
The connector socket can fit a
H05RN-F
or
H07RN-F
rubber
cable with 12 mm as maximum outer diameter and 1,5 mm
2
as
maximum conductor section; the cable must have three wires:
L (live) – N (neutral) – GND (ground)
.
25mm
"Self-piercing"
Tighten the nut using a
21 mm spanner
and connect the
socket to the plug on the LED luminaire and tighten the housing
to ensure
IP68 protection
. Test the luminaire before attaching it
to the final connection point.
Insert each wire into the socket terminal, matching wire color
with the “L”, “N” and “GND” symbol on the socket and tighten
the screws.
Remove the cable sheath a maximum of 25 mm. The wires do
not need to be stripped because the connector is equipped
with piercing clip terminals.
Insert the cable through the socket housing of the connector.
If the cable diameter is greater than 9 mm, remove the inner
part of the gasket.
Insert the socket into the housing until the inner part “clicks” in
and then insert the gasket.
POWER
3 POLE
CONTROL
2 POLE
CLICK
