CT590S user’s manual
| 23
4.
Press
1
on the main radio. The red led of the main radio and the green led of
the sub-radio will blink.
‘CL-OUT’
will appear on the display.
5.
When the two leds do not blink anymore, the LCD of the main radio shows
‘COPING’
and the sub-radio reboots: this means that cloning is finished.
Before using the radios, turn them off and then on.
Memory/Frequency Mode conversion (VFO/MR)
To switch between memory and frequency mode push
VFO/MR
.
TX 1750Hz Call Tone
Press
PTT + BAND
to send 1750Hz call tone. This function is useful for com-
munications through repeaters.
TX/RX Reverse function (R)
The reverse frequency function interchanges the TX frequency with RX. This
function is very helpful when you operate with a repeater; you can check whe-
ther it is possible to receive the communication from the other part without
the use of the repeater.
Note: Briefly press * to enable/disable this function.
Frequency scanning
This function can scan the frequency.
1.
In frequency mode , press
*
key for more than 2 seconds. The radio will start
scanning the frequency according to the set frequency step.
2.
You can change the scanning direction with the
▲
/
▼
keys.
3.
Press any key to stop the scanning.
Note: for Scan mode, see Menu No.16.
Channel scanning
This function can scan the channels.
1.
In frequency mode, press
*
key for more than 2 seconds. The radio will start
scanning according to the channel you set.
2.
You can change the scanning direction with the
▲
/
▼
keys.
3.
Press any key to stop scanning.
Note: for Scan mode, see Menu No.16.
Summary of Contents for CT590S
Page 31: ......
