10 |
BR01 instruction guide
Troubleshooting
Problem
Possible Cause
Solution
The radio doesn’t switch on
The battery pack is discharged and/or has not been installed
correctly.
Verify that the battery pack is charged and that it has been cor-
rectly installed.
The radio switches off shortly after it has been switched
on
Discharged battery pack.
Recharge the battery pack.
The battery pack does not recharge
The battery-charger has not been connected or installed cor-
rectly.
Inspect the connections of the battery-charger and the installa-
tion of the batteries.
The radio switches on but is unable to receive signals
The site of installation is too shielded.
Move to an another area.
The volume is too low
Adjust the volume level.
Incorrect CTCSS or DCS
Check that the CTCSS tone or DCS code corresponds to the
one set by the parties you are communicating with.
It is not possible to communicate with other parties
An incorrect radio channel has been selected.
Select the same radio channel used by the parties you are com-
municating with.
The radio is installed in a shielded area or is too far from the party
you are communicating with
Move to another area.
Incorrect CTCSS or DCS
Check that the CTCSS tone or DCS code corresponds to the
one set by the parties you are communicating with.
Reception is fragmented and/or disturbed
The signal is very weak.
Try temporarily disabling the Squelch by means of the Monitor
feature.
The transmission distance is excessive and/or there are obsta-
cles in the transmission path
Move closer to the party you are communicating with or to ano-
ther area.
Other parties are using the same channel
Check the traffic on the radio channel by means of the Monitor
feature and select another channel if required.
The radio has been installed too close to equipment that causes
interference (televisions, computers, etc.)
Increase the distance between the radio and this equipment.
The autonomy of the battery pack is limited
Commission time is too high.
Try reducing the transmission time and/or using a low power.
Summary of Contents for BR01
Page 2: ......
