Midland 777 PRO user manual
| 11
MENU button
Channel selection
1. Press the
MENU
button.
2. The number of the channel will start flashing on the display.
3. Press the
▲
/
▼
buttons to scroll up or down the PMR and then LPD channels
till you select the desired channel.
PMR446 traditional band: from P1 to P8
PMR446 new band: from 1 to 16
LPD: from 1 to 69.
4. Press the
PTT
button to confirm, or wait for 5 seconds.
CTCSS /DCS tones selection
777 PRO can receive in two modes:
•
Open traffic:
in this case you will hear any communication transmitted on the
selected channel;
•
Group mode CTCSS /DCS:
CTCSS/DCS tones are access keys that allow you
to receive only messages coming from parties using the same channel and code.
The speaker will remain muted until the correct tone is received.
To activate the 38 CTCSS tones/104 DCS codes in RX and TX:
1. Turn on the radio.
2. Select the desired channel.
3. Press twice
MENU
until the Display shows
“oF”
(blinking on the right side).
4. By pushing the
▲
/
▼
controls the display will show CTCSS (
“ct”
blinking) or
DCS (
“dc”
blinking); press
MENU
to enter the CTCSS or DCS tones. Now
select the desired tone with the
▲
/
▼
keys.
5. To confirm the setting, press the
PTT
key or wait for approximately 5 seconds
Selecting high or low transmission power (PMR band)
Batteries are drained more quickly during transmission. In order to extend the bat-
tery life you can select the low power when transmitting over short distances.
To activate the low power:
1. Press the
MENU
button for 4 times and “
Pr H
” will be displayed.
2. Select “
L
” using the scroll buttons
▲
/
▼
.
3. Press
PTT
to confirm, or wait for 5 seconds.
If you want to transmit over a longer distance repeat the above procedure to select
the high power. At step 2 select
“H”
. When the batteries are in good conditions,
high power is 500mW, whereas low power is 10mW.
A low battery level during transmission will reduce the performance of your device
.
