11
FMP:
This refers to Midian’s signaling protocol used in the GPS speaker microphone minus the GPS location
information.
FMP w/GPS:
This refers to Midian’s signaling protocol used in the GPS speaker microphone including the GPS
location information.
Protocol Format:
This displays the format selected on the ANI tab.
Fleet ID:
This field only applies to FleetSync and sets the Fleet ID for the ENI.
Unit ID:
This sets the Emergency ANI of the unit.
Message:
This field only applies to G-Star.
Status:
This field only applies to G-Star.
Transmit Forever:
If selected the ENI will transmit continuously at the repeat interval until canceled.
Busy Lockout:
When it is time to transmit the ENI, if this box is not checked the transmission will take place
regardless of whether or not the channel is busy. If this box is checked and the channel is busy (as indicated by
COR or VOX), the ENI will not be transmitted. Instead the unit will wait 2.3 seconds and then check again to see if
the channel is busy. If the channel is not busy at that time, the ENI will be transmitted. If, not the process will
repeat indefinitely.
Transmit Count:
This sets the number of times the ENI will be sent.
Repeat Interval:
This sets the time between ENI transmissions.
PTT Resets/Cancels ENI:
If selected, pressing the PTT button will either reset the Lone Worker’s Transmit Delay
time or cancel the transmission of the ENI.
Live Mic Enable:
If selected the unit will enable the mic of the radio to transmit mic audio to the dispatcher.
Revert to Clear:
This will switch the TX mode to Clear when using Live Mic.
Locator Tone Enable:
If selected the unit will emit tones out the speaker after all Emergency ANI’s have been
sent. This feature is not available if Transmit Forever is checked.
