Midea WWK08CW71E, User Manual

Page: 11 / 17

10
AIR CONDITIONER FEATURES
O O
Shows the set temperature in C or F . While on
Fan only mode,it shows the room temperature.
DISPLAYS:
Error codes:
AS-
Room temperature sensor error-Unplug the unit
and plug it back in.If error repeats, call for service.
NOTE:In Fan only mode,it will display L0 or HI .
ES- Evaporator temperature sensor error-Unplug the
unit and plug it back in. If error repeats, call for
service.
After the unit has stopped, it can not be restarted
operation in the first 3 minutes. This is to protect the
unit. Operation will automatically start after 3 minutes.
DISPLAYS:
Displayed in COOL mode operation.
Displayed in FAN mode operation.
Displayed in ENERGY SAVER mode operation.
Displayed in WiFi feature operation.
Displayed in CHECK FILTER mode operation.
L0 Displayed when room temperature is lower
O O
than 0 C/32 F.
HI
Displayed when room temperature is higher
O O
than 37 C/99 F.
Special features:
Wait 3 minutes before resuming operation
Auto Restart
If the unit turns off unexpectedly due to the power
cut, it will restart with the previous function setting
automatically when the power resumes.
Energy Saver feature
This function is available on COOL automatically. The
fan will continue to run for 3 minutes after the
compressor shuts off.The fan then cycles on for 2
minutes at 10 minute intervals until the room
temperature is above the set temperature, at which
time the compressor turns back on and Cooling Starts.
Timer: auto start/stop feature
Set the auto start/stop unit time no matter what the
unit is on or off.
Turning the unit ON or OFF at any time
will cancel the Auto Start/Stop timed program.
Swing feature
Press the SWING button of the remote controller for
2 seconds to start louver auto swing feature. Short
press the button to use to change the louver movement
and set the desired air flow direction.
WiFi feature
For the first time to use WiFi feature, press the WiFi
button for 5 seconds to turn off the unit and initiate the
WiFi connection mode. The LED DISPLAY shows AP
for 1 second and off for 2 seconds circularly to indicate
you can set WiFi connection. If connection is success-
ful within 8 minutes the unit will exit WiFi connection
mode automatically and the WiFi indicator illuminates.
If connection is failure within 8 minutes, the unit exits
WiFi connection mode automatically.
Auto Defrost
When frost builds up on the evaporator coils, the
compressor will cycle off and the fan will continue
to run until the frost disappears.
NOTE : If an operation has not been selected within
10 seconds, the display will dim. Display will brighten
again when an operation is selected.
NOTE : When the louver is horizontal, the unit will be
perfect cooling efficiency.
CAUTION
Never operate the louver manually.
Note during the network configuration process, do
not try using the remote control or the controls on the
front panel of the air conditioner, as they will be
inoperative. You may use the remote control and front
panel buttons again after the network configuration
process is complete (usually 8 10 minutes)