4
CONTROL PADS ON THE DEHUMIDIFIER
1
1
22
55
Co n t r o l p anel(1 )
C o n t rol pa n e l ( 2 )
3
3
1
1
2
2
4
4
Indicator lights
Power on indicator light(green)
Continuous operation on indicator light(green)
Bucket full indicator light(red)
Display
Shows the set % humidity level while setting, then shows
the 5% accuracy) room % humidity level.
Error Codes:
E1
- Humidity sensor error--Unplug the unit and plug
it back in. If error repeats, call for service.
E2
- Temperature sensor error-- Unplug the unit and
plug it back in. If error repeats, call for service.
Protect Codes:
P1
- Unit is defrosting-- Allow the unit to automatically
defrost. The portect will clear after the unit self defrosts.
P2
- Bucket is full or bucket is not in the right position--
Empty the bucket and replace in the right position.
55
POWER Pad
Press to turn the dehumidifier on and off.
6
6
Continue Pad
Select for the dehumidifier to operate
continuously for maximum dehumidification
until the bucket is full. The Humidity set
control pads cannot be used when
Continuous operation is on.Press this pad
again to cancel Continuous operation.
7
7
Humidity Set Control Pads
The humidity level can be set within a
range of 35%RH(Relative Humidity) to 80%
RH(Relative Humidity) in 5% increments.
For drier air, press the pad and set to a
lower percent value(%).
For damper air, press the pad and set to
a higher percent value(%).
Control pads
The control panel of the dehumidifier you purchased may be look like one of the following:
1
1
2
2
3
3
4
4
5
5
6
6
7
7