Midea NY2009-20MR, Owner'S Manual

Page: 13 / 16

”key for along time to quickly set the scheduled time
，
and the scheduled time will
[Inspection before start]
1.The power cord shall not be damaged or fractured.
2.Please verify the rated current of the power socket is in line with the requirements
in the table above and is equipped with a safety grounding device before use; oth-
erwise, replace the socket.
[Operating Instructions]
<
Work/Standby >: Plug in the power,the buzzer will “beep” for along time,press the
power key “ ” to enter the heating working state,and then press the
power key “ ” to enter the standby state.
<Gear selection>: For work status, press “ ” key to select one of work modes
such as high gear, medium gear and low gear .
OPERATING INSTRUCTION
<Temperature Setting>:Under the working status,press and hold the“ ”key or“ ”key
to set the temperature,press and hold the“ ”key or the“ ”key to quickly set the tem-
perature;after setting the temperature,have non-operation for 5 seconds,exit the tem-
perature setting screen.
-
<Scheduled work>:Tap the timer key" " in standby mode to enter the scheduled
work setting screen. Press“ ”key or“ ”key to set the scheduled time, press“ ”key
or“
<Scheduling standby>:Under the working status,press the timer key" "to enter the
scheduling standby setting screen.Press“ ”key or“ ”key to set the scheduling time,
<Memory function>:When started up the machine again and it will operate according
to the status before the last standby.
press“ ”key or“ ”key for along time to quickly set the scheduling time,and the
scheduling time is in the standby state to the machine.
A:the scope of scheduling is for 0~24hours,and press" "key or" "key each time to
increase or decrease 1 hour.When the set value is 0H,press the" "key to set the
time for 24H.When the set value is 24H,press the" "key,and the setting time is
0H.When the set value is 0H,the scheduling is canceled. When the set value is not
0H,the scheduling is started.Set the appointment time,press the timing key" "key or
" "key,or without operation for 5 seconds,exit scheduling mode.
B:If the scheduling time isset,press the power button " "to enter the standby state and
cancel the scheduling.
C:After the scheduling is started,press the scheduling key" "to check the remaining
time of the appointment and reset the scheduling time.During the scheduled time,the
machine is shut down or started upunder temperature control,and the scheduled time
is always normal,and free from down time.During the scheduled time,it is cleared
incase of power failure
.
reach the working status of the machine.