Midea NTH20R, Manual

Page: 16 / 17

PRODUCT SPECIFICATION
Model
Low
High
Power regulation range
NTH20-21R 1200W 2000W 1200W 2000W
Low osc High osc
TROUBLESHOOTING
If the product does not operate or does not operate properly, first check according to the following
list. If the reason the product does not operate or does not operate properly is not included in the
following list, the product mayhave failed. At this time, it is recommended to send the product to
the dealer for treatment.
Problem
Possible Cause Solution
After the power is
engaged,the machine
does not work
.
The plug may not be
plugged well.
Check whether the plug is
properly inserted in to the
receptacle.
The machine suddenly
stops during heating.
The temperature exceeds
the threshold of the
thermal cut- o .
then in sert it into the receptacle
again
when the machine is cooled.
CLEANING AND MAINTENANCE INSTRUCTION
1. The electric heater should be cleaned regularly to wipe out the dust on the surface of flanges.
As this may influence the radiating efficiency.
2. Disconnect electricity supply and allow radiator to cool, wipe out dust with a soft damp cloth.
Do not use detergent or abrasives.
3. Do not scrap the surfaces of flanges with sharp hard tools, prevent damage of the paint coat.
Remote control
Turn on/off
the Swing
button
ON/OFF button
Funtion button
Button of temperature / time increase
Timing button
(AAA battery 1.5V)
Power assembly
drawing
Button of temperature / time
decrease
ECO button
Control range of remote controller
The remote controller control can be normally
used within 5 meters in front of the product
and in the left and right angles of 30 degrees.
Please use a manganese or alkaline battery
of type "AAA" and do not use a non-recycla
-
ble battery.
Power
supply
220-240V~
50-60Hz
199x209x603mm
2.8kg
Product size
(LxWxH)
Net
weight
and
6