The cont rol pane l can be clea ned by using a lightly dampened cloth.
After cleaning, m ake sure to dry it thoroug hly.
For t he exterior, use a good appliance pol ish w ax.
Never use sharp objects, scouring pads or harsh cleaners on a ny part of the dishwasher.
Protect Against Freezing
1.Cut off the electrical power to the dishwasher.
2.Turn off the wat er suppl y and disconnect the water inlet pipe from the water valve.
3.Drain the water from the inlet pipe an d water valve. (Use a pan to gather the water)
4.Reconnect the water inl et pipe to the water valve.
5.Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
please take frost protection measures on t he dishwasher in winter. Every
fter washing cycles,
please operate as follows
time a
：
Cleaning the Filter
Cleaning the Door
To clean the coarse fi lter and the f ine f ilter, use a c leaning b rush. R eassemb le the fi lter p arts as show n in the figures
on the last page and reinsert t he entire assembly in the dis hwa sher, positio ning it in its seat and pressing dow nwards.
When cleaning the filters, don't knock on them. Otherwise, the filters could be
contorted and the perform ance of the dishw asher could be decreased.
To cle an the edge around the door, you should use only a soft warm, damp cloth.
To avoid pene tration o f water into the door lock and electrical components, do not
use a spray cleaner of any kind.
Never u se a spr ay cleaner t o clean t he door panel as it m ay dam age the door loc k
and electrical components.
Abrasive ag ent s or som e paper towels shou ld not be used becau se of the risk of
scratching or leaving spots on the stainl ess steel surface.
Cleaning the Spray Arms
I f your dishwasher cannot work because of the ice,
please contact professional service persons.
I t is necessary to clean the spra y arm s re gularly fo r hard
w ate r che micals w ill clog the sp ray arm jets a nd bearings.
- Inspect the filters for blo cking a fter e very time the dishwa sher has been used.
- By unscrew ing the coarse fi lter, you can rem ove the filter system . Re move any foo d remna nts and
clean the fi lters under runni ng water.
Remarks:
The entire filter assembly should be cleaned once a week.
To remove th e lower spray arm, pull out the spray arm u pwa rd.
To remove the up per spray arm, hold the nut, rotat e the arm
clockwise to remove i t.
Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.