3.TROUBLESHOOTING
P.10
3.2.6 Pressure switch checking (t06)
1) Enter into service mode, drain out the water, LED displays LL.
2) Press
button to activate inlet valve. LED displays level frequency once water lever get
the main wash level.
3) Press
3.2.7 Water temperature sensor and heater checking (t07)
1) Press
button to activate the main inlet valve and get the water lever to heating level then
turn on the heater and 5 min later turned off automatically.
2) After heater turned on, LED displays the current temperature. Detect the real temperature of inner
drum and check with the numbers on the display.
3) Press
button to exit, LED displays “t07”
3.2.8 Inlet valve checking (t08)
Enter into service mode, drain out the water, LED displays “UU”
Press
button, LED displays “u3”and switch on the main wash inlet valve for 10 min.
4) Press
button, LED displays “u2” and
3.2.9 Rotating checking (t09)
1) Enter into service mode, LED displays “tUB”
2) Press
button, inner drum rotates in 45r/m clockwise for 15s and stop for 10s then rotates
counterclockwise for 15s, over and over again.
3) Press
button to turn off the motor and exit, LED displays “t09”.
3.2.10 Spin speed checking (t10)
1) Press
to enter into service mode, LED displays “spn”.
2
he number on the display goes up in the same pace with the real speed
and when it reach 400rpm, you need to press
button to get the machine to reach its target speed.
( if declared speed
≥
1000rpm, target speed is 1000rpm and if declared speed
＜
1000rpm,target speed is
its declared speed)
3) Press
button to exit and LED displays “t10”.
3.2.5 Drain pump checking (t05)
1) Enter into service mode, LED displays “PPt”.
2) Press
button to drain out all the remaining water. If all water drained out, LED displays
“EP”
，
and 6 minutes later ,if there is still water remains in it, LED displays “FP”.
3) Press
button to exit, LED displays “t05”
1)
2)
3) Press
button, LED displays “u1” and switch on prewash valve for 5s.
switch on the main wash inlet valve for 5s.
5) Press
button to switch on main wash and prewash valve and get the water lever to setting
level, then drain out the water.
) Press
button again, t
[K5]
[K5]
[K5]
[K2] button 4 times to start water inlet valve for water supply, after the water level reaching
the overflow line, drain out all the water.
[K5]
[K5]
[K5]
[K2]
[K2]
[K2]
[K5]
[K5]
[K5]
[K5]
[K2]
[K5]
3.2 Sevice mode