Midea HS-338FWEN-W, Instruction Manual

Page: 24 / 41

19
1)
Loosen the plastic clips
2) Replace the fan motor, the inverse operation to
complete installation
Damper assembly None
8.5
Evaporator and temperature sensing system
Evaporator in freezing chamber
1
）
Remove the air duct components in freezing
chamber.
2
）
Disconnect all connectors.
3
）
Remove the welding on inlet and outlet tubes.
4
）
Remove two screws which are used to fix the
evaporator and remove the evaporator.
Components on the evaporator
❶
Fuse
The fuse is located on top of the evaporator
1
）
connect the fuse connector.
2
）
Cut off the band which fixes the fuse.
3
）
Separate the fuse and the evaporator.
*Don’t break the welding of the evaporator in case that
only the fuse needs to be replaced.
❷
Defrost sensor
The defrost sensor is located on top of the evaporator.
1
）
Disconnect the connector of defrost sensor
2
）
Cut off the band which fixes the sensor.
3
）
Separate the sensor and the evaporator.
*Don’t break the welding of the evaporator in case that
only the sensor needs to be replaced.
❸
Defrost heater
The defrost heater is located at bottom of the evaporator.
1
）
Disconnect the connector of defrost heater.
2
）
Cut off the band which fixes the defrost heater.
3
）
Take off the defrost heater from the evaporator.
*Don’t break the welding of the evaporator in case that
only the defrost heater needs to be replaced.
❷
❶
❸