5.Rapid cooling mode
Press B key to select Rapid cooling mode , the 3 icon shows, then press D key to
confirm, the refrigerator will be running according to Rapid cooling mode.
6.Quick-freeze mode
Press B key to choose Quick-freeze mode, the 2 icon shows, then press D key to
confirm, the refrigerator will be running according to Quick-freeze mode.
7. Refrigerator compartment temperature settings
Press C key once,the Refrigerator compartment temperature displays with
flashing,press C key again and you can set the temperature ,the range of temperature
is from 2
°
C to 8
°
C
8. Freezer room temperature settings
Press A key once,the Refrigerator room temperature displays with flashing,press D
key again and you can set the temperature ,the range of temperature is from -l6
°
C to
-24
°
C.
Note:when
the set temperature of freezer changes, if set relevant function mode
(e.g. quick-cold mode, quick-freezer mode,quick-cold and freezer mode,
vocation mode), the relevant function mode should be quitted or canceled at once.
Announcements
ethe refrigerator use alternating current supply which is
220-240V/50Hz.
If the voltage
fluctuations is large( Over the scope of
198-264V
), it may cause some failures,such as
the refrigerator does not start, The main control board and compressor bum and the
compressor works with abnormal voice. etc.At this time you must install an automatic
voltage regulator which is above
1000w
for use. The refrigerator power's cord with a
three-plug (grounding)complies with the standard three-socket (grounding).Don 't cut
off or remove the third pin of the power card under any circumstances. After the
refrigerator is installed , Plugs should be able to reach to facilitate use. the power Plug
must be firmly contacted with the socket, otherwise it might cause fire.
• Do not grasp and drag the power cord to pull out the refrigerator plugs.Hold the
plug firmly , and pull out the plug from the socket directly . Do not let power lines are
pined by the refrigerator or trampled by people. Be careful when the refrigerator will
be removed from walls. Do not roll or damage power lines, Do not use power lines
and plugs When they were damaged or worn out. Go to the service center which the
factory assigns to replace power lines if they were worn out or damaged.
10
Summary of Contents for HC-683WEN(ESNY)
Page 20: ...make yourself at home...
