Remove all packaging material before
using the new refrigerator. This
includes the foam base and all
adhesive tape holding the refrigerator
accessories inside and outside.
Clean both the inside and outside of
the refrigerator with wet cloth (a little
detergent could be added into the
warm water to wash the cloth and
then wipe it again with the clean
water);
Prepare an independent two-pole
socket with grounding contact for the
refrigerator and it shall not share a
multi-purpose socket with other
electrical appliances;
Do connect grounding wire! The
grounding pole of the socket shall be
provided with a reliable grounding
wire.
Open the refrigerator body and take
out the accessory (decorative cover
for bottom beam) and the three
screws from the instruction
packaging bag; then install them into
the bottom beam as shown by the
schematic diagram on the right.
The decorative cover for bottom
beam is used as ornament, so you
can choose not to install it. It won't
affect the refrigerator's performance
or conditions no matter whether you
install it or not.
Installation
Transport and Placing of Your
Refrigerator
Transport
Keep upright and avoid squeezing or
vibration during transport. Avoid a
slant angle over 45 degree during
handling.
Avoid the door or top cap from being
under excessive stress when moving;
otherwise, it may become deformed.
Placing
Place your refrigerator in a well-
ventilated place and keep it from heat
source and direct sunlight. Don't
place it in any humid or wet place so
as to avoid rust and weakening of
insulation effect.
There shall be a space not less than
30cm from the top of your refrigerator
and not less than 10cm from both
sides or the back of the refrigerator to
the adjacent walls respectively. This
requirement is good for open and
close of the door and also for heat
emission.
The refrigerator shall be placed on a
flat and firm ground (if not flat, you
can use the leveling legs for
adjustment).
Keep Your Refrigerator Standing
Don't connect your refrigerator to the
power supply immediately after it is
placed vertically. You should keep it
standing for at least 6 hours before
switching it on in order to ensure it
running well.
Make sure the power wire is not
pinned by the refrigerator or other
objects so as to avoid accidents
arising from power wire faults. Please
check the voltage scope of your
refrigerator against the actual power
supply before switching it on.
07
08
Attention
The refrigerator must be disconnected
from the source of electrical supply
before attempting the installation of
accessory.
Don't use mechanical equipment or
other methods to accelerate the
defrosting process except the means
recommended by the manufacturer.
Don't use any electrical appliances in
the food storage compartments except
the model recommended by the
manufacture.
The R134a refrigerant and cyclopentane
foaming material used in the refrigerator
are inflammable. All waste and
discarded refrigerators shall be placed
away from naked fire and they are not
allowed to burn.
Screws
Decorative cover for bottom beam
