6
1) Disconnect the power supply cord from the outlet.
2) Remove the screws from the rear and along side
edges of the case.
The outer case must be moved backward to be
1) Remove the outer case.
2) Disconnect two terminals, and remove one screw of
the earth terminal.
1) Disconnect the leadwire from the PCB SUB ASS’Y.
2) Remove the screws for the earth and securing the
control panel.
3) Lift control panel ASS’Y from the oven by the tab
unhooked.
DISASSEMBLY AND ADJUSTMENT
1. OUTER CASE REMOVAL
2. POWER SUPPLY CORD REMOVAL
3. CONTROL PANEL ASSEMBLY REMOVAL
lifted off.
Remove Control Assembly
Remove door Assembly
Remove door Assembly
1) Open the door.
CAUTION : Be careful not to damage Door C
by screwdriver.
3) Lift up and pull the door.
NOTE:
1. After replacing the door, be sure to check that the
primary switch, monitor switch, and secondary switch
operate normally.
2. After replacing the door, check for microwave energy
leakage with a survey meter. Microwave energy must
be below the limit of 5 mW/cm
2
. (with a 275 ml water
load)
3. When mounting the door assembly to the oven
assembly, be sure to adjust the door assembly parallel
to the chassis. Also adjust so the door has no play
between the inner door surface and oven frame
assembly. If the door assembly is not mounted
properly, microwaves may leak from the clearance
between the door and the oven.
to the Cavity Ass'y.
2) Remove two screws holding the Hinge
4. DOOR ASSEMBLY REMOVAL
