INSTALLATION & OPERATION MANUAL 10305 REV 1 (08/22)
PAGE
7
OF20
Self-Generating Steam Jacketed Counter Tilting Kettle
O
peration
O
PERATION
Operating
I
nstructions
1. Ensure that the external electrical shut-off to the kettle is on.
2. Check pressure gauge for correct cold kettle reading. Reading should be in the green vacuum zone. If reading is not
in the vacuum zone, follow VENTING INSTRUCTION prior to using the kettle.
3. Place power switch in ON position.
4. Preheat the kettle by placing thermostat knob at maximum and wait until TEMPERATURE light goes off.
NOTICE
Preheating should not be used when cooking milk and egg food products which adhere to hot cooking surfaces.
These foods should be placed into kettle before heating is begun.
5. Add food to be cooked into the kettle.
6. Place thermostat knob at required temperature setting with a temperature range from roughly 165 °F to 289 °F
(74 °C to 143 °C, jacket temperature.)
7. When cooking is finished set thermostat knob and power switch to the OFF position.
8. Pour finished product from kettle using tilt handle. Be careful to avoid splashing.
9. Add water to kettle for cleaning purposes.
10. Wash kettle thoroughly. See CLEANING procedure.
T
ilting
I
nstructions
Your kettle has the standard “Clean Lock” feature and may not be tilted without disengaging the tilt knob located
on the console at the top right. This feature locks the kettle in the upright position and also allows the operator
to lock the kettle at 105 degrees for ease of cleaning. To tilt the kettle the full distance, the tilt lock knob must
be disengaged from the cleaning position by pulling out the tilt lock knob and tilting the kettle forward the full
distance. Follow these steps to tilt kettle:
1. Pull out the tilt knob near top right of console.
2. Using kettle tilt handle pull kettle forward to desired angle of pour or until kettle locks at 105 degrees. The tilt
knob can be released after the kettle has been tilted approximately 10°.
3. Kettle will lock in position at 105 degrees and may be tilted further by pulling the tilt lock knob a second time
allowing the kettle to tilt the full distance.
4. To return the kettle to the upright position, pull out the tilt lock knob and tilt the kettle upward until it locks in
the upright position. The kettle should not move in either direction once in the upright position.
