Middle Atlantic C3-XX-LDXU, Instruction Sheet

Page: 9 / 14

FIGURE G
NOTE :
• If you are not securing uprights using the provided SNAPTOGGLE anchors (preferred), and
instead are going into wood studs or a solid concrete wall, you must provide your own lag bolt
hardware.
• For more information, refer to “Attaching Your Frame Using the Default (Frame Feet) Installation
Height” on page 6 in the C3 Series Credenza Frame instruction sheet (100-00032).
ATTACHING UPRIGHT PAIR TO THE FRAME AND YOUR WALL (CONTINUED)
7. Insert the studs on the bottom (inner post) on one of the macro
height secured uprights into the holes on the top of the frame as
shown. ( FIGURE G )
NOTE
: Verify the torque on your power driver is on the lightest setting
and only increase as necessary.
8. Use power driver, ⅜” socket and (2x) 10-32 flange nuts (D) to
attach the upright to the frame.
9. Repeat the previous steps to attach the other upright.
10. Use power driver, Phillips bit, ¼”-20 x 2½” bolts (E),
and ¼” washers (F) to secure uprights to your wall.
Do not overtighten.
3. Use a pencil and mark your wall inside the top slots of the 4 upper keyholes
on the uprights (A) as shown. ( FIGURE F )
4. Remove the uprights from your frame and wall.
NOTE : Adjust torque on power driver to the “drill” setting.
5. Use power driver and ½” drill bit to drill holes in all marked locations
on your wall.
6. Insert SNAPTOGGLE
®
anchors (C) into holes by holding metal channels
flat alongside plastic straps and sliding channels through holes.
NOTE
:
• Refer to “Attaching Your Frame Using the Default (Frame Feet)
Installation Height” on page 6 in the C3 Series Credenza Frame
instruction sheet (100-00032) to revisit instructions on how properly
use SNAPTOGGLE anchors in your type of wall.
• If you are not securing uprights using the provided SNAPTOGGLE
anchors (preferred), and instead are going into wood studs or a solid
concrete wall, you must provide your own lag bolt hardware.
Page 9
Mark inside the top slots of the 4 upper
keyholes for drill locations.
NOTE : A 1-Bay C3 credenza with
display mount option (C3-XX-LDXU)
configured for a single display
(displays not included) shown.
Top of
C3
Frame
A
Studs
WARNING: All four upper keyholes specified in these instructions are the minimum anchor points
required when securing the uprights to the wall.
AVERTISSEMENT: Les quatre trous de serrure supérieurs spécifiés dans ces instructions sont
les points d'ancrage minimum requis lors de la fixation des poteaux verticaux au mur.
FIGURE F
A
D