BACKPAN
LIFT
ROTATE
Page 3
Tools needed:
- Socket wrench set
- Power Drill and bit set
1) Disassembly required prior to mounting. Open door on faceplate. To do this, door must be slightly
lifted and opened to the service position (105º) (See
FIGURE A
)
2) Remove 6 nuts that secure the faceplate to backpan and remove faceplate. (See
FIGURE B
)
FIGURE A
FIGURE B
DECORATOR STYLE
KNOCKOUT
UCP
PANEL
FACEPLATE
CLAMP
3) Using customer supplied mounting hardware specified
below (6 places), mount backpan to wall. (see
FIGURE C
)
Block Wall Installation:
1) 5/8" pilot hole
2) 1/4" X 2" toggle bolt and washer
Wood Stud Wall Installation:
1) 1/8" pilot hole in center of stud
2) 1/4” X 2" lag bolt and washer
4) Re-assemble faceplate to backpan by re-using 6 nuts.
(See
FIGURE B)
FIGURE C
16.00
[406]
24.60
[625]
MOUNTING
HOLES
ASSEMBLY
NOTE:
Do not use 8.5" x 8.5" square
knock-out in backpan when flush mount
installed. Knock-out must remain in place.
