JOINING TABLETOP HALVES (2-PIECE TABLETOP MODELS ONLY, CONTINUED)
Page 21
2. With tabletops shifted to one end exposing the joint connector holes, insert (4x) joint connectors
(J, with hex hole facing downward) and use 5mm hex bit to tighten the seam. (
FIGURE AE
)
FIGURE AE
J
Joint Connector
Holes
NOTE
: Install joint
connector with 5mm hex
hole facing downward.
Tabletop
Seam
Pedestal Base
Mounting Plate
FIGURE AF
D
ATTACHING THE BASE ASSEMBLY TO THE TABLETOP(S)
NOTE
: To protect the wood finish from scratching, do not place any parts or tools on the unprotected
tabletop surface during assembly. For wood kit care and cleaning, refer to I-00788.
1. Align pre-drilled holes on the bottom of the tabletop(s) (D, halves for 2-piece tabletop models, single
piece for 1-piece models) with the holes on the pedestal base mounting plates. (
FIGURE AF
)