Page 3
REQUIRED TOOLS
• #2 Phillips Screwdriver (at least 6” long)
• Drill
INSTALLATION
NOTE:
Installation of the brackets must be done with the C5 top off.
1. Remove the side panel on the side you wish to install the shelf.
2. Prepare your side panel based on the following C5 models:
• For Thermolaminate and HPL C5 models,
englarge pre-drilled mounting holes from
the inside of the side panel using a 1/4”
drill bit
(FIGURE A)
.
• All other models already have pre-drilled mounting
holes.
3. Hammer T-nuts into each of the holes from
the inside of the side panel.
(FIGURE A)
4. Install shelf brackets using the following screws based on your C5 model:
FIGURE A
NOTE
: On Klasik C5 models, one less T-nut
and screw is used because there is no hole in
the location closest to the front hinge plate.
T-Nuts
(6)
Mounting
Holes
(6)
• On Sota and Klasik C5 models, use
10-32 x 3/4” screws.
(FIGURE B)
• On Moderno C5 models, use
10-32 x 1 3/4” screws.
Use 3 screws per bracket and leave them loose
for any necessary adjustments.
• 1/4” Drill Bit
• Hammer
FIGURE B
NOTE
: On Klasik C5 models, one less T-nut
and screw is used because there is no hole in
the location closest to the front hinge plate.
Summary of Contents for C5 SERIES CREDENZA RACK
Page 6: ......
