EQUIPMENT LOADING AND SQUARING PANELS
To eliminate the possibility of a center bow in the
frame, Middle Atlantic Products suggests that the
squaring panels be left in place until some of your
components have been mounted.
RACK ASSEMBLY (Continued)
3) Install (4) 10-32 Hex Head screws through top and bottom frames into each rackrail.
(FIGURE B)
4) Install (2) squaring panels on front and rear of assembly using (4) 10-32 x 1/4” screws. Locate
squaring panels at the mid-point of rackrail assembly.
(FIGURE B)
5) If supplied, install (2) support brackets on pre-installed rackrail mounting studs using (2) 10-32 hex
head screws per bracket.
(FIGURE B)
6) Lay assembly on a flat, level surface and square frame on all four corners. (
FIGURE C
)
7) Tighten all flange nuts.
FIGURE B
Squaring
Panels
(2)
Hex Head
Screws 10-32
(4 Per Rackrail)
Screws 10-32
(4 Per Squaring
Panel)
Top Frame
Bottom Frame
Rackrail
(CORRECT)
(INCORRECT)
Page 8
Hex Head
Screws 10-32
(2 Per Support
Bracket)
Support
Brackets
(2)
FIGURE C
