User Interface Manual
© Copyright 2006 Microwave Data Systems Inc. All Rights Reserved
3-24
MDS FIVE Series
05-4574A01, Rev. C
5. Scroll through the options for the following parameters using the Space
Bar key and press the “Enter” key to select among the options.
a. Device Selection
b. Serial Byte Format
c. Data Baud Rate
6. To update the edited parameter, press the hotkey for “Update”.
7. The page is refreshed and displayed with the updated or current/present
values.
8. If parameters are not updated with entered values, the value entered may
be invalid for that parameter.
3.3.9.4 SNMP Configuration
1. Select a parameter from the MIB section ccmSDIDUSysCfgSerial
2. Use the SNMP GET command to get the value of the required parameter
3. Use the SNMP SET command to set the value of the required parameter
4. The SNMP agent will return the actual value upon successful set or get
operation. Upon failure, the SNMP agent will return an error if the value set
is out of range, or the agent is not able to get or set the value, or the user
does not have access rights to the selected parameter
3.3.10 Device Information
User Access Level: Level 1
Figure 3-14. Device Information.
3.3.10.1 Description
The screen shown in Figure 3-14 is a read-only information
page that provides the
user with terminal related information. The parameters listed on this page are:
Model Number
– Model number of the terminal
