Quick Start Guide 3
miriac SBC-T1024 User Manual
V 2.3
12/70
© MicroSys Electronics GmbH 2017
3.2
Board Preparation and Power-Up
■
Make sure the switches SW1 and SW2 are set properly in order to select the
correct boot source and board configuration
■
The board comes preconfigured to boot correctly on arrival.
■
Connect the mini USB cable to ST5.
■
Connect other peripherals (USB, LAN, SATA, ...) as far as intended.
■
Connect the power line to the ST3 connector, while the power supply is still
switched off.
■
Switch on the power.
Figure 3-1 System setup example (LAN port 4)
All manuals and user guides at all-guides.com
