Copyright © 2016
Microsemi
Page 17 of 48
Rev. A00
CPG
– PoE BU
One Enterprise Aliso Viejo, CA 92656 USA
Eng
lis
h
Appendix A.
Safety and Warnings
The following chapter contains safety information and
warnings.
Safety Information
Installation and removal of the PDS-104GO must be carried
out by qualified personnel only.
The PDS-104GO "DATA PWR OUT" ports are shielded RJ45
data sockets. They cannot be used as Plain Old Telephone
Service (POTS) sockets. Only RJ45 data connectors can be
connected to these sockets.
Follow basic electricity safety measures whenever connecting
the PDS-104GO to its power source.
A voltage mismatch can cause equipment damage and may
pose a fire hazard. If the voltage indicated on the label is
different from the power outlet voltage, do not connect the
PDS-104GO to this power outlet!
All wiring and connections shall be in accordance with NFPA
70 (NEC)
This product is not intended to become a permanent part of
the building structure.
Power supply cord must not be attached to the building
surface or run through walls, ceilings, floors and similar
openings in the building structure.
Measures must be taken to prevent physical damage to the
power supply cord, including proper routing.
WARNING
Do not use a cross-over cable between the PDS-104GO
output port and load device
Take extra care when connecting the AC power, so that 'N', 'L'
and ‘Ground‘, are connected to the proper polarity.
Ensure the AC power is within the allowed range.
