4.2.2
Cables
Depending on your requirements, you can use any of the cables listed below. Cable connectors are keyed
so that you can't insert them incorrectly. For more information about cabling options for your RAID controller,
visit
Note: We recommend using only Microsemi Adaptec SAS cables.
SAS HD Cables (Series 8 controllers)
Internal SAS HD to SAS HD (SFF-8643 to SFF- 8643)—Connects to
a backplane or enclosure.
External SAS HD to SAS HD (SFF-8644 to SFF- 8644)—Connects to
a backplane or enclosure.
4.3
Replacing the Full-Height Bracket with a Low-Profile Bracket
If you are installing your Microsemi Adaptec RAID controller into a low-profile computer cabinet, replace
the original full-height bracket with the low-profile bracket included in your distribution kit. The full-height
bracket is mounted on the front of the controller, the low-profile bracket is mounted on the back of the
controller, as shown in the figure below.
Front of board
Full-height bracket
Back of board
Low-profle bracket
To replace the full-height bracket with the low-profile bracket:
1. Remove the full-height bracket from the controller board. The full-height bracket is installed on the
front side of the controller, with the mounting screws inserted from the back of the controller, as shown
in the Figure 1.
13
Microsemi Proprietary and Confidential. Installation and User's Guide Revision 5
Getting Started
