Microscan HawkEye 1600T, Manual

Page: 28 / 79

Chapter 2 System Components
2-8 HawkEye™ 1600T Smart Camera Guide Rev. 1G, Dec 2008
• SN — The serial number of your HawkEye™ 1600T Smart Camera.
• MAC ADDRESS — This unique address is important because, by default, a
HawkEye™ 1600T Smart Camera’s name on the network is
“HawkEyeXXXXXX,” where XXXXXX is the last six alphanumeric
characters in its MAC address. So, for the HawkEye™ 1600T Smart Camera
with MAC address 00:60:33:E1:FF:FA, the default network name is
“HawkEyeE1FFFA”.
• Optional IntelliFind License Key (applies to HE1610TIS & HE1610TIH
only)
Power-on Sequence
Each stage of the power-on sequence drives the LEDs in a binary up-count
fashion according to Table 2–5. The LEDs illuminate before the test is executed
and remain in that pattern until the next test is run or an error condition is
detected and displayed.
Error Codes
In the event of an error being detected, an error code (in binary form)
representing the test that failed flashes on the LEDs. The LEDs continue to flash
until the <Escape> character is sent on the serial port, at which point an error
message is logged to the serial port and the Diagnostic Monitor is launched. The
serial port terminal server must be set to the following parameters: 115200, 8, N,
1.
Table 2–5 describes the Mode/Status LED power-on sequence and error codes.
TABLE 2–5.
Mode/Status LED Power-On Sequence & Error Codes
Mode Fail Pass Trig Test Performed
• Data Line Test
• Address Line Test
• • Bootloader CRC Check
• Kernel CRC Check
• • RS-232 Internal Loopback
• • FPGA Load Test
• • • FPGA PCI Config Test