Micronor MR380-1-3, Instruction Manual

Page: 9 / 29

MR380-1-3 Instruction Manual
Page 9 of 29
3. MR380-1-3 Controller Installation and Operation
Mounting the MR380-1-3 Controller Module
The controller unit mounts on DIN rails as well as a single mounting clip. Both mounting schemes
are shown below in Figure 4 .
Figure 4. MR380-1-3 Mounting Options: DIN Rail Mount versus Chassis Mount
Connecting the MR380-1-3 Controller Module
An LC Duplex optical cable is used to interconnect the sensor and controller. The sensor
incorporates a 3m optical pigtail (or alternate length as specified by customer). If a longer
connection to the controller is required, then an extension cable having an LC Duplex connector
may be used.
Remove the LC Duplex connector's dust cap(s) and open the external shutter of the controller.
When inserting the LC Duplex connector, there should be a positive click when the connector is
engaged properly. Avoid repeated fiber optic disconnects to reduce likelihood of surface
contamination.