Micronics U1000MKII-FM, User Manual

Page: 54 / 56

U1000MKII User Manual Micronics
Page 50 Issue 3.1 July 19
6.5.6 Data Entry Errors
These generally advise you that the data entered is not within the specified range:
Displayed when an invalid Pipe ID is entered, prompting the user
to enter a value between 20 and 165mm depending on the product
purchased.
An attempt has been made to zero the offset between the
temperature sensors, and the difference in temperature is too
large. Ensure the temperature sensors are correctly plugged in
and are both at the same temperature.
When programming a Frequency Pulse output the frequency is
limited to the range 1 to 200 Hz.
When programming a Volume Pulse output the pulse width is
limited to the range 3 to 99ms.
When programming the Zero Cut-off this is limited to the range
0.000 to 0.500.
NOTE: THIS MUST BE SET TO ZERO BEFORE PERFORMING
A ZERO OFFSET.
When programming the Calibration Factor this is limited to the
range 0.5 to 1.5.
Range 20.0
–
165.1
0.000 mm
Calibrate Error
Press Enter
Range 1 - 200
200
Range 3 - 99
0000.0
Range 0.00
–
0.500
0000.0
Range 0.500
–
1.500
0000.0