Installation of the M4Pe
The installation of the M4Pe system board depends on the type of case you
have. Prior to installing the M4Pe, make sure you have a clear work space
available and adhere to all anti-static precautions.
If you are unfamiliar with installing a motherboard, it is highly recommended
you read the computer user’s manual or contact your dealer’s technical
support department.
Tools Required
Micronics recommends using the following tools to install the M4Pe:
m
Small Phillips screwdriver.
m
Tweezers or a pair of needle-nose pliers.
m
Tray (to hold loose screws).
Equipment Required
Micronics recommends using the following equipment with the M4Pe for a
typical configuration:
m
Chassis with standard hardware.
m
A high quality power supply capable of providing continuous power
within a 5 volt range, plus or minus 5% (eg. 4.75 to 5.25). A power
filter may be added for areas with noisy transmission.
m
AT compatible keyboard.
m
Eight ohm speaker.
m
Standard ribbon cables for internal connections.
m
Shielded AC power cable (grounded).
m
Heat sink (for DX2 and DX4 processors).
Micronics M4Pe System Board Manual
3-2
