Cyclone System Board Manual
Chapter 4: The BIOS Setup Utility
40
Set User Password
This selection controls access to the Setup utility. Press
the ENTER key to enter the User Password submenu.
The following screen appears:
Type the password and press the ENTER key. Retype the
password and press the ENTER key again. Write down
the password somewhere safe so it will not be forgotten.
The password may be disabled by setting the new pass-
word to nothing (pressing the ENTER key without first
typing a password).
NOTE: After a password is entered, it is saved immediately.
All other changes may still be discarded (see Exit Screen).
Set Supervisor Password
This selection controls access to the Setup utility. Follow
the same procedure used to set the User Password.
WARNING: If you forget the Supervisor Password, it cannot
be disabled without discharging the CMOS.
Figure 4-7: Supervisor Password Submenu
