Micronics M5Pi System Board Manual
3-6
Installing a CPU
The M5Pi is designed to support 60 or 66MHz Pentium processors. Follow
the steps below to install a processor:
1.
Turn off the computer and remove the computer cover.
2.
Locate the ZIF socket illustrated in Figure 2-1.
3.
Lift the lever of the socket.
4.
Locate pin 1 on the processor and pin 1 on the socket (Figure 2-1).
Gently set the processor into the socket, making sure
pin 1 on the processor and pin 1 on the socket are aligned.
5.
Push the lever down until it locks into place.
6.
Make sure the CPU selection jumpers are set correctly (Chapter 2).
Warning:
Pentium processors require a heat-sink with a cooling fan. Failure to
provide adequate cooling of the processor may seriously affect system
performance or cause permanent damage to the processor.
