-7-
Chapter 2 Hardware Installation
2.1. Panel Layout
2.1.1. Front Panel
Figure 2-1 Front Panel
RESET
When RESET is pushed, system settings will be set to factory defaults.
M1&M2
System status indicators,
Orange
. M1 is flashed once per second to
indicate system is alive. When system is busy, M2 is lighted.
WAN & LAN
Ethernet port indicators,
Green
. The LED flickers when LAN or WAN
port is sending or receiving data.
Link/Act.
Link status indicators,
Green
. The LED flickers when the corresponding
port is sending or receiving data
10/100
10/100 status indicators,
Green
. The LED flickers when the
corresponding port is transmitting or receiving data in 10 or 100Mbps.
Port 1 - 4
LAN port socket (RJ-45). These are where you will connect to device on
your local area network, for example HUB and switch.
2.1.2. Rear Panel
Figure 2-2 Rear Panel
PRINTER
Parallel port connector (25-pins D-type female). This is where you will
connect the shared printer.
(
Optional
)
WAN
WAN port socket (RJ -45). This is where you will connect to your cable (or
DSL) modem or Ethernet router.