LED Indicator
For definitions of LED indicators, please refer to the following
table:
4
1
2
3
Hardware Installation
The setup of the switch can be performed using the following
steps:
Step 1: Connect the AC Power Adaptor to SP6005P4 and then
to a power outlet.
Step 2: Enable PoE port manually with dip switch 'On'.
Step 3: Connect a RJ-45 Ethernet cable from IEEE802.3af-
compliant devices (PD) to an available PoE port of
SP6005P4.
Step 1:
Step 1:
Step 1:
Tour of the System
Front Panel
LED indicators, dip switch and one uplink port
Dip Switch Configuration
The DIP switch can be switched 'ON' or 'OFF' anytime for PoE
function enabled/disabled.
On/Green
Power is off
Power is on
Operation
The Ethernet port is connecting
with the device.
On/Green
Blink/Green
POWER
Off
LED
Status
LINK
Off
Introduction
The SP6005P4 supports IEEE 802.3af and pre-802.3at standards
for Power over Ethernet (PoE) with the maximum power delivery
up to 48 Watts. That makes it suitable to various applications that
demand for remote power feeding and meet high level requirement
for power. In addition, the SP6005P4 is equipped with DIP switch
for per-port PoE enabled/disabled. It effectively helps allocate
power for connected devices and enhances network management.
Key Features
Compliant with IEEE 802.3af and pre-802.3at standards
Supports Power over Ethernet on 4 RJ-45 ports of 10/100M
Provides 61.6W (max) feeding power to 4 PDs: 15.4W for each
Able to delivers high power to 1/2/3 PDs: 48/30/20W for each
Supports power protection as OVP (Over Voltage Protection),
OCP (Over Current Protection), OTP (Over Temperature
Protection), and SCP (Short Circuit Protection)
Supports robust surge protection
Equipped with DIP switch for per-port PoE enabled/disabled
LED indicators for PoE activity
Package Contents
Before you start installing SP6005P4, please verify the following
package contents:
SP6005P4 10/100M PoE Switch
Quick Installation Guide
AC/DC Power Adaptor
Power Cord
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Back Panel
RJ-45 PoE ports and work with DC48V/1.25A adaptor
PoE
Receiving or transmitting data.
No device attached.
On/Green
Off
PoE port is active.
PoE port is not active.
*48
1
Maximal power on
Each PoE Port (Watts)
Number of Enabled
PoE Ports
2
3
4
*30
*20
15.4
Note:
1. It is suggested that the dip switch is set ready before the PoE
port is connected.
2. (*) The SP6005P4, with pre-802.3at compliant, provides
Extended power levels 48/30/20 watts for higher power
applications.
1.
1.
1.
1
2
3
4
OFF
ON
PoE Control
