Micromeritics AccuPyc 2 1340, Operator'S Manual

Page: 59 / 158

AccuPyc II 1340 System Commands
Aug 2013 3-25
Calibrate
This command enables you to perform a full volume slope and offset calibration; enter a temperature
or pressure value obtained from an external reference device; copy to or load from a USB stick; and
reset the pressure calibration.
Press
ALT
+
.
(decimal) to access the Calibrate function.
Enables you to choose the insert you are using.
Choices: None, 0.1 cm
3
(for 1 cm
3
unit)
None, 3.5 cm
3
, 1.0 cm
3
(for 10 cm
3
unit)
None, 35 cm
3
, 10.0 cm
3
(for 100 cm
3
unit)
None, 650 cm
3
, 1300 cm
3
(for 2000 cm
3
pycnometer)
Refer to MULTIVOLUME INSERTS , page J-1 for
additional information on MultiVolume inserts.
Press
CHOICE
until the appropriate insert is displayed or
None if an insert is not being used, then press ENTER .
Choose one of the following:
• Press
ENTER
to start the analysis.
The analysis begins and operational status messages are
continually displayed during analysis.
• Press
Alt + CLEAR
to cancel the analysis.
• Press
SAVE
to store the data you entered and return to dis-
play mode.
Choices: Volume, Temperature, Pressure,
Copy to USB Stick, Load from USB Stick,
Reset Pressure Calibration
Press
CHOICE
until the desired option is displayed:
Press
ENTER
.
Unit[n] SN1234 10 cm3
Analyze
Chamber insert?
None
Unit[n] SN1234 10 cm3
Analyze
[ENTER] to start
[Escape] to cancel
Unit[n] SN1234 10 cm3
X - X - X
Calibration Type?
Volume