Micromeritics AccuPyc 2 1340, Operator'S Manual

Page: 141 / 158

AccuPyc II 1340 Appendix J
June 2013 J-1
J. MULTIVOLUME INSERTS
The MultiVolume Insert option enables you to analyze samples using smaller-sized sample
chambers with your AccuPyc. MultiVolume Inserts are available as follows:
• AccuPyc 2000-cm
3
capacity ; includes 650- and 1300 cm
3
cups, supporting inserts and
calibration standards. A tool is also included to allow removal of the supporting inserts.
• AccuPyc 100-cm
3
capacity ; includes 10- and 35-cm
3
inserts with corresponding sample
cups and appropriate calibration standards. A fritted filter lid, which prevents the escape
of sample particles under rapid gas flow, is included for the 10-cm
3
insert.
• AccuPyc 10-cm
3
capacity ; includes 1- and 3.5-cm
3
inserts with corresponding sample
cups and appropriate calibration standards. Fritted filter lids are included for both inserts.
• AccuPyc 1-cm
3
capacity ; includes a 0.1-cm
3
insert/sample cup combination.
Refer to Ordering Information for the appropriate part number and ordering information.
Operating Parameters
Operating procedures using inserts typically are the same as when not using them. However,
you do have to request that a prompt display during the procedures allowing you to choose the
MultiVolume insert you are using. Perform the following steps to have a
Chamber Insert
prompt display during standard operations.
1. Press Alt + 2 to access the Set Up function.
2. Press
CHOICE
until Report Options is displayed, then press
ENTER
.
3. Continue pressing Enter until the Request Insert prompt is displayed.
4. Press
CHOICE
until Yes is displayed, then press
ENTER
.
5. Press SAVE to save the change(s) and return to the Reload prompt.
A Chamber Insert prompt will display during all normal operating procedures, allowing you
to choose the appropriate insert. For example, a Chamber Insert prompt will display when
starting a calibration or analysis.
Unit[n] SN1234 10 cm3
Report Options
Request insert?
Yes