Microlife FR1DG1, User Manual

Page: 6 / 53

Test Protocol (for laboratory use)
1. Press and hold the START button for 10 seconds until the
unit beeps, then release.
2. Wait for the screen to stop showing numbers, turn grey,
and show dashes.
3. At that time place the thermometer into the blackbody and
press the start button to take the measurement.
TYPE
IP22: Protected against solid foreign objects of 12.5mm
diameter and greater. Protected against vertically falling water
drops when the device is tilted up to 15°.
Type BF Applied Part
SERVICE
When the device is not in use, battery/access (if applicable)
may be replaced by the user. No other parts/components are
accessible.
Batteries and electronic instruments must be disposed of in
accordance with the locally applicable regulations, not with
domestic waste.
It is recommended that this digital thermometer be checked for
accuracy every 2 years
Expected life of thermometer: 5 Years
FCC
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation. Changes or modifications to the
product are not approved by Microlife USA and could void the
user's authority to operate the equipment under FCC jurisdiction.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
4